×
- Live Chat
- 1-888-726-6993
My Garage
My Account
Cart
Genuine Nissan 300ZX Antenna
Radio Antenna- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
7 Antennas found
Nissan 300ZX Antenna Kit
Part Number: 28200-44P01$791.37 MSRP: $1117.75You Save: $326.38 (30%)Ships in 1-3 Business DaysNissan 300ZX Antenna Kit
Part Number: 28200-30P00$838.31 MSRP: $1117.75You Save: $279.44 (25%)Ships in 1-3 Business DaysNissan 300ZX Antenna Kit
Part Number: 28200-44P00$838.31 MSRP: $1117.75You Save: $279.44 (25%)Ships in 1-3 Business Days
Nissan 300ZX Antenna
If you need any OEM Nissan 300ZX Antenna, feel free to choose them out of our huge selection of genuine Nissan 300ZX Antenna. All our parts are offered at unbeatable prices and are supported by the manufacturer's warranty. In addition, we offer quick shipping to have your parts delivered to your door step in a matter of days.
Nissan 300ZX Antenna Parts Questions & Experts Answers
- Q: How do you disconnect and replace a power antenna on Nissan 300ZX?A: Remove the negative cable from the battery and tie it away from the negative terminal to ensure that there is no accidental reconnecting of the negative to the battery and thus supply power back into the circuit of the car. Some of the panel will require the removal some of them are such as; rear luggage compartment trim piece, driver's side rear trim piece. Access the internal component area of the handheld and unplug the control cable by pulling the electrical connector in the same manner Polaroid used when disconnecting the antenna cable from the assembly; that is, by pulling the cable in the center only. Discard the two screws that secure the power antenna to the body and then pull off the antenna mast retaining nut from the position on the fender panel. Descend the power antenna from the fender, and take out of car. To install the new power antenna, slide the mast into the fender hole and put the mast retaining nut on and tighten it only lightly, put the two lower retaining nuts on the antenna and tighten them only lightly on the body. Pre-tighten the screw of the mast retaining nut and the two lower antenna retaining bolts. Screw the antenna cable and the antenna electrical connector in; install the side panel trim piece; at last, screw in the rear luggage compartment trim piece. Last but not the least, reconnect the negative cable to the battery.
