Nissan 56200-6B026 ABSORBER Kit-Shock, Rear

You can Select Your Vehicle to check if 56200-6B026 fits your vehicle.

The first step in the installation process is to position the shock absorber onto its mounts.

If replacing the lower insulator, set it into position with the dropped portion seated in the lowest part of the seat, extend the damper rod fully, and install the dust boot. Place the compressed coil spring onto the lower insulator, ensuring the end rests in the lowest part of the insulator. Install the upper insulator and spring seat, ensuring the cutout on the spring seat faces out, in line with the strut-to-knuckle flange opening. Install the bearing onto the spring seat, followed by the dust seal and suspension support to the damper shaft. Finally, install and tighten the nut to the specified torque, carefully release the tension on the spring, and remove the spring compressor before installing the strut coil spring assembly.

Guide the brake hose through its bracket in the strut and install the retaining clip, then install the wheel and lug nuts, lower the vehicle, and tighten the lug nuts to the specified torque before tightening the upper mounting nuts to the specified torque.

Regular inspection of the steering linkage and suspension components is crucial because worn or damaged parts can lead to various problems such as abnormal tire wear, compromised ride quality, poor vehicle handling, and reduced fuel efficiency. It helps ensure the safe and efficient operation of the vehicle.