Nissan 48203-3U025 Boot Kit-Manual Steering Gear

You can Select Your Vehicle to check if 48203-3U025 fits your vehicle.

Loosen the lug nuts, raise the vehicle, and support it securely on jackstands before removing the wheel. Next, remove the tie-rod end and jam nut. Take off the outer rack and pinion boot clamp by pinching the ends together with pliers, and cut off the inner boot clamp using diagonal cutters, then slide the boot off. Before installing the new boot, wrap the threads on the end of the steering rod with tape to prevent damage to the small end of the new boot. Slide the new boot into position on the rack and pinion until it seats in the groove on the steering rod and install new clamps. Remove the tape and install the tie-rod end. Finally, install the wheel and lug nuts, lower the vehicle, and tighten the lug nuts to the specified torque, then have the wheel alignment checked by a dealer service department or an alignment shop.