Nissan 26717-9B904 Bulb

You can Select Your Vehicle to check if 26717-9B904 fits your vehicle.

To replace front turn signal lights The lens is remove by unscrewing it and pulling it out As for the holder one has to unscrew it counterclockwise and easily pull the bulb out. For front combination lights, open the bonnet, locate the screw behind the headlight housing and remove it then pull the combination light off forward in a way that will get it out of the body of the car. Turn the bulb holder anti-clockwise to unlock it and then pull it out using the arms while holding the bulb. For rear turn signal, brake, and tail lights for model 1998 and below, remove the lift gate and pull the access panel for bulb holders while for model 1999 and above, open the rear hatch, remove the screw and pull the lamp assembly out. To change a bulb, unscrew the bulb holder in anti-clock wise direction and then pull out the bulb. For tail light and backup lights, open the liftgate then you need to remove the access panel by unscrewing it, you also need to rotate cap of the bulb holder anti-clockwise and pull it and finally pull the bulb. The brake light is positioned at the top of the car and therefore, the bulb holder must first be exposed by unscrewing from the car chassis, The bulb of the holder can be unscrewed by rotating them in anti-clockwise direction. For license plate lights replacement of bulbs involve, unscrewing to take out the assembly, clips on the lens housing need to be unclipped on bulb holder to be taken out and finally pulling the bulb directly. Instrument panel light'reachable after the complete disconnection of the instrument cluster; clockwise rotation to unlock; to replace the bulb, ensure to use the same wattage. Dome, door, vanity, and cargo lights consist of prying off the lens to remove that, bulbs are removed by releasing the clips and pulling the bulb while being careful to pry on any glass at the ends, if needed. Removal is the exact process of installation but in the reverse sequence of the function.

Reinstall the retaining ring and the electrical connector, then test the headlight operation.

To access the headlight bulbs, detach the plastic inner fender liner at the front edge and pull it back.

Loosen the trunk lid finish panel, twist the bulb socket counterclockwise to remove it, pull the bulb out to replace it, and reinstall by reversing the steps.