Nissan 14950-ZT60A CANISTER Assembly E

You can Select Your Vehicle to check if 14950-ZT60A fits your vehicle.

To replace the purge control solenoid valve one has to first loosen the bolts and remove the engine cover, then disconnect the hoses from the valve, which consists of electrical connector, two hoses, two mounting nuts. After that, unbend the electrical connector and unscrew the mounting nuts to demount the valve from the bracket and mounting while the procedure of mounting inverses the process. For a canister that is situated under the vehicle, near the right rear wheel, you need to lift the car and place it on secure jackstands. First, the EVAP canister protector has to be taken off by unscrewing the shield fasteners Next all the connectors have to be disconnected including electrical connectors of the control pressure sensor and the vent control valve, the canister purge hose, the fuel tank EVAP breather hose, and the vent control valve hose have to be removed. Take out the canister retaining bolts and then take out the EVAP canister; to install simply reverse the process. The pressure sensor which is part of the EVAP control system is connected to the canister with its base; to release it, the individual merely has to pull out the whole sensor whereas the vent control valve is loosened by turning the valve counter clockwise and then pulled out. Clean the O-ring in acetone if needed, and look for splits or damage; replace in needed because installation is the opposite procedure of removal.

The function of the evaporative emissions control system is to draw fuel vapors from the gas tank and fuel system, store them in a charcoal canister, and then burn them during normal engine operation.