Nissan 33146-33G00 Catcher Oil

You can Select Your Vehicle to check if 33146-33G00 fits your vehicle.

Carefully pry the old seal out of the extension housing using a seal removal tool or a large screwdriver.

Remove the flange nut, withdraw the flange, pry out the old seal and discard it. Lubricate the lips of the new seal and the seal case with multi-purpose grease. Tap the new seal evenly into position with a seal installation tool or a large socket. Install the companion flange and apply a bead of RTV sealant to the ends of the splines visible in the center of the flange. Install the nut and tighten it to the specified torque. Finally, install the driveshaft and check the lubricant level, adding the recommended type of lubricant to reach the bottom of the filler hole if necessary.

Raise the vehicle and support it securely on jackstands. A flange holding tool or chain wrench will be required to keep the companion flange from moving while the nut is loosened.

To replace the seal, start by raising the vehicle and ensuring it's securely supported on jackstands.

Carefully pry the old seal out of the extension housing using a seal removal tool or a large screwdriver.

Mark the relationship of the lever to the shift shaft, detach the linkage from the lever, then loosen the pinch bolt and slide the lever off the shaft. Carefully pry the seal out of the case. Lubricate the new seal with multi-purpose grease and install it over the shaft, tapping it into place with an appropriately sized deep socket. Install the lever onto the shaft and tighten the pinch bolt securely. Reconnect the linkage to the lever, install the bolt and tighten it securely. Finally, check the lubricant level and add the recommended type of lubricant to reach the bottom of the filler hole if necessary.