Nissan 48810-ET00A Column-Steering Tilt

You can Select Your Vehicle to check if 48810-ET00A fits your vehicle.

Loosen the clamp on the negative terminal of the Battery then emerge the cables out of the wheel well and move the wheels to the straight-ahead position then unbolt the steering wheel. Subsequently, you should unlock and take off the upper and lower steering column shoe, in addition to the combination switch and the spiral cable. After that, the driver's knee bolster should be removed together with the specific disconnection of each of the switch connectors mounted on the steering column. Pull and unplug the steering column wiring harness clip, then take out the upper intermediate shaft-by unscrewing the bolt, and remove the intermediate shaft that is in the column. Disconnect the steering column nuts and pull the steering column out then, take out the lower intermediate shaft bolt as well as the shaft. The process of removal is followed by the opposite procedure, each bolt is tightened to the required torque and battery is connected and all relevant relearn is done.