Nissan 80600-1B325 Cylinder Set-Door Lock,RH

You can Select Your Vehicle to check if 80600-1B325 fits your vehicle.

The procedures apply to both front doors and the sliding door except where noted. To address the door latch, begin by removing the door trim panel and watershield, then take out the screws securing the latch to the door. Detach the locking rods and pull the latch assembly through the access hole, ensuring to position it as necessary to disengage the outside door handle and lock cylinder from the latch rods. All door locking rods are attached by plastic clips, which can be removed by unsnapping the engaging portion and pulling the rod out. Next, position the latch to disengage it from the door lock solenoid if equipped, and remove the latch assembly. For the lock cylinder and outside handle, raise the window and remove the door trim panel and watershield. Disengage the plastic clip securing the lock cylinder to the latch rod, then slide the lock cylinder retaining clip out and remove the lock cylinder. For front doors, remove the door glass run retaining screw, then disengage the outside handle-to-latch rod and remove the two handle retaining nuts to take off the handle. On sliding doors, remove the outside handle retaining nuts, detach the link, and pull the handle from the door. The installation process is the reverse of removal. For the inside handle, remove the door trim panel and watershield, then on front doors, take out the bolt securing the inside handle, rotate it out, detach the two links, and remove it. On sliding doors, remove the screws and link securing the inside handle control mechanism. Installation is again the reverse of removal.