Nissan H0601-ET000 Cylinder Set-Door Lock,LH

You can Select Your Vehicle to check if H0601-ET000 fits your vehicle.

To gain access to the both front and rear doors firstly disconnect the power window switch and further take off the door trim panel and water-shield. Make sure the window is shut tight, then remove the door glass run channel. Secondly, locate and take out the door side grommet and the bolt for the door key cylinder trim panel if necessary after pulling out the grommet. On the key cylinder side turn the connection rod of the key cylinder off. If the vehicle is equipped with an intelligent key system, the procedures include disconnecting the door antenna and the door request switch connector together with the removal of the harness clamp. Move on to the removal the door lock cylinder and cover assembly, while tugging on the outside handle until it is in the forward position.Pull out the outside door handle and move it to the rear of the vehicle for easy removal. The front and rear gaskets should be pulled out then the door lock assembly mounting bolts. Sliding the outside handle bracket rear ward will require the removal of the assembly, and in addition of this, the detachment of the door lock assembly electrical connector if present. Lastly, cut the connection between the outside handle cable and the outside handle bracket, while installation is the exact opposite of removal.

Raise the window, then remove the door trim panel and watershield. Remove the door glass and the door module, which includes the large panel with the electric motor. Take out the rubber plug from the edge of the door to access the door handle bolt beneath it, then remove the bolts from the door lock cylinder on the driver's side or the handle trim on the passenger's side. For vehicles equipped with the Intelligent Key system, disconnect the door antenna and the door request switch electrical connectors, and remove the wiring harness clamp. Disconnect the cable, lock cylinder rod, and electrical connector by detaching the plastic clip from the lock rod, then pull the rod out of the hole in the clip along with the door handle mounting bolt and electrical connector. Pull the outside door handle to remove the lock cylinder assembly on the driver's side or the handle trim on the passenger's side, ensuring to disconnect the electrical connector of the door request switch. Slide the outside handle rearward to remove it along with the gaskets, being careful not to lose them. Remove the bolts from the door edge and take out the lock assembly, noting that the latch mounting bolts are located in the door edge. Remove the bolt from the outside handle bracket and slide the bracket to the rear for removal. Disconnect the door lock actuator and remove the lock assembly by disconnecting the cables from the latch. Installation follows the reverse order of removal.