Nissan C7126-ZE00J Kit Journal

You can Select Your Vehicle to check if C7126-ZE00J fits your vehicle.

Using a vise, press one bearing cap into the yoke approximately 1/4-inch. Use chassis grease to hold the needle rollers in place in the caps. Insert the cross into the partially installed bearing cap, taking care not to dislodge the needle rollers. Press both caps into place by slowly and carefully closing the vise jaws, using a socket slightly smaller in diameter than the caps to press them into the yoke. Install one snap-ring, then press the other side to shift the cross assembly tight against the installed snap-ring and install the other snap-ring.

For 4WD models, repeat these checks for the front driveshaft and inspect the slip yoke for leaks. Additionally, examine the driveshaft connections to the transfer case and front differential for oil seal wear and inspect the front driveaxle joints for looseness and grease or oil leakage from the rubber boots.

This PN is for one.