Nissan 14002-ZJ60A Exhaust Manifold With Catalytic Converter Passenger Side

You can Select Your Vehicle to check if 14002-ZJ60A fits your vehicle.

Because of the Federally-mandated extended warranty covering emission-related components such as the catalytic converter, it is advisable to check with a dealer service department before replacing the converter at your own expense. Begin by raising the vehicle and securely supporting it on jackstands. Apply a liberal amount of penetrating oil onto the threads of all fasteners to be removed. Disconnect the downstream oxygen sensor electrical connector and remove the sensor from the exhaust pipe. Unscrew the two nuts fastening the exhaust pipe (catalytic converter) to the exhaust manifold, retaining the exhaust clamp springs. Next, unscrew the two nuts fastening the exhaust pipe (catalytic converter) to the center muffler, again retaining the exhaust clamp springs. Remove the exhaust pipe (catalytic converter) and discard the front and rear exhaust gaskets. For installation, reverse the removal process using new exhaust gaskets, ensuring the springs are properly located by aligning them with the dimples in the exhaust flanges, and apply anti-seize compound on all bolts and nuts.

Disconnect the cable from the negative terminal of the battery. Block the rear wheels and set the parking brake. Loosen the right front wheel lug nuts, then raise the front of the vehicle and support it securely on jackstands before removing the right front wheel. Remove the engine splash shields and the right inner fender splash shield, followed by the drivebelt. Disconnect the electrical connector from the oxygen sensor and remove the heat shield from the exhaust manifold. Disconnect the exhaust pipe from the exhaust manifold, noting that applying penetrating oil to the fasteners may facilitate removal. Remove the exhaust manifold brace and then the exhaust manifold-to-cylinder head nuts in the reverse order of the tightening sequence to detach the manifold and gasket. For installation, use a scraper to eliminate all traces of old gasket material and carbon deposits from the mating surfaces of the exhaust manifold and cylinder head. Position the new exhaust manifold gasket over the cylinder head studs, install the manifold, and thread the mounting nuts into place. Tighten the nuts to the specified torque in the correct sequence. The remainder of the installation follows the reverse order of removal, using anti-seize lubricant on the exhaust pipe studs. Finally, reconnect the battery and perform the necessary re-learn procedures.

YES , THIS WILL BE CARB COMPLIANT

No the gaskets are sold separately