Nissan 27220-1W600 Motor & Fan Assy-Blower

You can Select Your Vehicle to check if 27220-1W600 fits your vehicle.

Disconnect the cable from the negative terminal of the battery. Remove the glove compartment and lower dash trim to gain access to the heater case and blower motor. Detach the blower motor vent hose and disconnect the electrical connector from the blower motor. Remove the blower motor mounting screws, and pull the blower motor carefully out of the housing. If replacing the motor, detach the fan and transfer it to the new motor. Installation is the reverse of removal. Run the blower and check for proper operation.

To test the blower motor's operation, you can use jumper wires. Disconnect the electrical connector from the blower motor and connect a jumper wire between the ground wire terminal on the blower motor and a good chassis ground. Then, connect a fused jumper wire between the battery's positive terminal and the positive terminal on the blower motor.