Nissan 44060-01P93 Disc Brake Pad Kit

You can Select Your Vehicle to check if 44060-01P93 fits your vehicle.

To replace the front brake pads, first jack up the vehicle and place it securely on jack stands and then remove the front wheels. Then, unbolt the lower pin retainer bolt of the front brake caliper while swinging the caliper up to slide off the brake line retaining clip at the hose bracket on the strut. To gain access to the brake pads you will have to raise the caliper body up further, and then remove both the inner and outer shims with a view of noting the placements that they occupied. Gently removal of the brake pads must be done by avoiding the application of the brake pedal. If the pads are glazed, damaged or worn, they must be replaced and ideally all four pads on the axle must be replaced at the same time, using the same material. Remove the pistons and clean the end of the piston and pin bolts with brake fluid and not the mineral based solvent. Coat the contact surfaces between the torque member and the pads with silicone-based greases and install the retainers and pads back, make sure that the grease does not touch the friction areas. Secure the piston with a small C clamp Arrange the reservoir fluids in a way that they do not spill out when the the piston is compressed. Lower the caliper body little by little and fit the lower pin bolt in the hole provided for it and tighten it up to the standards. Push the brake pedal several of times to allow the pads to wear in before reinstalling the wheels, and lifting the car off the jackstands. To change rear brake pads, lift the vehicle and set it on jack stands and unbolt the emergency brake cable at the turn buckle of the adjusting type. Pull off the cable retaining spring clip and take the emergency brake cable end out of the retaining bracket. Pop the lower caliper retaining pin and lift the caliber; do not second that this caliper will open fully as a result of hydraulic brake hose. Cautomatically to the fully assembled position and remove the pads with the shims attached Lift out the pad retainers wash the parts in brake fluid. It is advisable to apply silicone based grease on the contact areas before fixing the pad retainers, you should check the condition of the pads as well. Pull the piston back into the cylinder body using needle nose pliers and fit the shims on to the pads and the pads are then fitted back into the caliper and the caliper then lowered. Place the lower caliper retaining pin and fasten the spring clip over the emergency cable, and the emergency cable end fits into its slot. Last but not the least, apply the brake very hard for several times in order to get the brake pads seated or bedded in, adjust the cable of the emergency brake, and then lift the jack stands off the ground to allow the vehicle to descend.