Nissan 80721-2Y000 Regulator Assy-Door Window,LH

You can Select Your Vehicle to check if 80721-2Y000 fits your vehicle.

Remove the door trim panel and the plastic watershield. For 2003 and earlier models, take out the window glass, unclip the power window electrical connector, and remove the Window Regulator motor mounting bolts. Next, remove the bolts at the top and bottom of the Window Regulator frame, which may require the removal of the door panel support brace to extract the Window Regulator and motor through the door opening. Pull the Window Regulator through the service hole to remove it, and installation is the reverse of removal. For 2004 and later models, if working on a front door, remove the door window glass, unbolt the module from the door, disconnect and unclip the wiring harness, then lift the module out, detaching the motor or Window Regulator if necessary. For a rear door, unbolt the glass and lower it to the bottom of the door, unbolt the motor/Window Regulator unit, unplug its wiring connector, and lift it out. Installation is the reverse of the removal steps.