Nissan 33111-01J00 Seal Oil Transfer Cover

You can Select Your Vehicle to check if 33111-01J00 fits your vehicle.

Pry out the old seal and discard it. Lubricate the lips of the new seal and the seal case with multi-purpose grease. Tap the new seal evenly into position with a seal installation tool or a large socket. Install the driveshaft and check the lubricant level, adding the recommended type of lubricant to reach the bottom of the filler hole if necessary.

Oil leaks are often caused by wear of the extension housing oil seal, located at the extreme rear of the transmission.

Use a seal driver, a large section of pipe, or a very large deep socket as a drift to install the new oil seal into the extension housing.

Finally, install the driveshaft, being careful not to damage the lip of the new seal during the installation.

Pry out the old seal and discard it. Lubricate the lips of the new seal and the seal case with multi-purpose grease. Tap the new seal evenly into position with a seal installation tool or a large socket. Install the driveshaft and check the lubricant level, adding the recommended type of lubricant to reach the bottom of the filler hole if necessary.

Mark the relationship of the lever to the shift shaft, detach the linkage from the lever, then loosen the pinch bolt and slide the lever off the shaft. Carefully pry the seal out of the case. Lubricate the new seal with multi-purpose grease and install it over the shaft, tapping it into place with an appropriately sized deep socket. Install the lever onto the shaft and tighten the pinch bolt securely. Reconnect the linkage to the lever, install the bolt and tighten it securely. Finally, check the lubricant level and add the recommended type of lubricant to reach the bottom of the filler hole if necessary.