Nissan E4302-ET00B STRUT Kit Front RH

You can Select Your Vehicle to check if E4302-ET00B fits your vehicle.

If, for example, the struts or coil springs that have wear that include leaks, loss of damping ability, or even mechanical damage, it's important to investigate all your options before working on it since strut/shock absorber assemblies are non-serviceable and need to be replaced in case of a problem. Some strut assemblies may have springs, and their components can be rather time-consuming to source individually; therefore, before dismantling the vehicle, compare the costs and availability of exchange parts. To disassemble, turn the strut thereby pulling the spring assembly out and then fit it in a wooden vise padded with rags and should not over tighten. Adjust a spring compressor in a manner consistent with the manufacturer's guide to reducing tension in the upper spring seat as confirmed by horizontal vibrations. If required, dismantle the piston rod nut with the help of an Allen key, and then unscrew the upper suspension stop and check the rotation of the bearing, if necessary, it needs to be replaced. Raise the spring seat and the upper insulator of the piston rod and examine the rubber spring seat for the deterioration: if it is worn out, replace it. Now raise the compressed spring from the assembly and put it aside, and now remove the dust boot from the piston rod and check the lower insulator for deterioration and, if deteriorated, get a new one. During reassembly, if installing the lower insulator, position it appropriately; and push the damper rod on the dust boot. Start by placing the coil spring on the lower insulator in a manner that the end of coil spring forms a part of the recess. Place the upper insulator and the spring seat in its position and make certain that the marks or the arrows match, replace the dust seal and the suspension support to the piston rod and tighten the nut to the necessary torque. Replacement of the strut/shock absorber and coil spring assembly is best done by placing it in the fender well and tightening and upper mounting bolts to the standard specified torque, which is rather heavy to do alone. After that, position the steering knuckle back to the flange of the strut assembly then put the bolt in place and tighten the nuts to the suggested torque. Perform the following actions to complete the removal: Reinstall the stabilizer bar link Put the wheel back on and tighten it to the required torque Tighten the nut of the wheel To final Ch it is recommended to have the front end alignment checked and adjusted if required.

If any undesirable conditions are found, proceed to disassemble the strut.

After loosening the lug nuts, raise the rear of the vehicle and support it securely on jackstands while blocking the front wheels to prevent rolling.