Nissan 18201-7B415 Wire-Accelerator

You can Select Your Vehicle to check if 18201-7B415 fits your vehicle.

Detach accelerator and cruise control cables from throttle lever, loosen locknut and adjusting nut, separate cable from bracket, pull cable end from pedal arm, disconnect clips, remove cable through firewall. Reverse for installation. Adjust accelerator cable by lifting to remove slack, turn adjusting nut until throttle lever moves, back off 1-1/2 to 2 turns, tighten locknut. Adjust cruise control cable by checking accelerator cable, turning adjusting nut until throttle lever moves, back off 1/2 to 1 turn, tighten locknut.

To adjust the accelerator cable, perform the following steps: Remove Slack: Lift up on the cable to remove any slack. Start Moving Throttle Lever: Turn the adjusting nut until the throttle lever just starts to move. Back Off Adjusting Nut: Back off the adjusting nut 1-1/2 to 2 turns. Tighten Locknut: Tighten the locknut to secure the adjusting nut in place. Check Throttle Valve Movement: Verify that the throttle valve opens fully when you depress the accelerator pedal to the floor and that it returns to the idle position when you release the accelerator.

If the Throttle Valve (TV) cable is not adjusted properly, it can lead to incorrect transmission shift points.

Depress the lock plate on the cable adjuster and pull the adjusting tube toward the adjuster. Release the lock plate, and with the assistance of another person, quickly depress the throttle to the full open position and then release it. Mark the cable where it exits the boot above the adjuster using tape or a grease pen.