Nissan 18201-0W000 Wire Assy-Accelerator

You can Select Your Vehicle to check if 18201-0W000 fits your vehicle.

Detach accelerator and cruise control cables from throttle lever, loosen locknut and adjusting nut, separate cable from bracket, pull cable end from pedal arm, disconnect clips, remove cable through firewall. Reverse for installation. Adjust accelerator cable by lifting to remove slack, turn adjusting nut until throttle lever moves, back off 1-1/2 to 2 turns, tighten locknut. Adjust cruise control cable by checking accelerator cable, turning adjusting nut until throttle lever moves, back off 1/2 to 1 turn, tighten locknut.

Remove the air filter housing. Pull up the Throttle cable and pass through a slot in the lever. Detach the cable casing from the bracket. Drain the transmission fluid, remove the fluid pan, and detach the cable from the lever and transmission. Detach the cable adjuster from the bracket, raise the vehicle, and support it firmly on jackstands. Depress the lock plate on the adjuster, pull the adjusting tube toward the adjuster, and release the lock plate. Have the assistant quickly depress the throttle open to full throttle. Mark the cable where it exits the boot and measure the total stroke of the cable.