Nissan 16119-7S00D Throttle Chamber Assembly

You can Select Your Vehicle to check if 16119-7S00D fits your vehicle.

1. Disconnect the negative terminal of the battery.2. Remove the air intake duct.3. Disconnect the electrical connector and coolant hoses from the throttle body.4. Remove the throttle body and discard the old gasket.5. Install the throttle body with a new gasket, ensuring proper torque.6. Check and adjust the coolant level if needed.

1. Perform the accelerator pedal release position relearn procedure.2. Perform the throttle valve closed position relearn procedure.3. Start the engine and warm it up to normal operating temperature.4. Turn the ignition switch to OFF and wait for at least 10 seconds.5. Verify that the accelerator pedal is fully released.6. Turn the ignition switch to ON and wait three seconds.7. Repeat a specific procedure five times within five seconds, fully depressing and releasing the accelerator pedal.8. After a certain time, fully release the accelerator pedal and start the engine, allowing it to idle for 20 seconds.9. Rev up the engine and check the idle speed and ignition timing.