Nissan 11370-96E20 Insulator-Sub Engine Mounting

You can Select Your Vehicle to check if 11370-96E20 fits your vehicle.

Final tightening should be done with the vehicle level and the powertrain weight on the mounts, using thread-locking compound on the nuts/bolts, ensuring bushings are not twisted or offset. If more than one mount has been replaced, the tightening order should be crossmember bolts, rear engine mount, front engine mount, left-side transaxle mount, and right side engine mount.

To replace the mounts, disconnect the cable from the negative battery terminal, set the parking brake, block the rear wheels, raise the front of the vehicle, and support it securely on jackstands while removing the splash shields. Support the engine from above, then remove the through-bolts from the right-front and right-rear mounts, detach the crossmember from the vehicle, and remove the mount-to-engine bracket through-bolts. Installation is the reverse of removal, ensuring bolts are tightened to specifications only after the engine weight is back on the mounts and the jack is removed.