Nissan 22060-56S10 Knocking Sensor

You can Select Your Vehicle to check if 22060-56S10 fits your vehicle.

The knock sensor is located on the right side of the cylinder block. Start by disconnecting the electrical connector. Following this, remove the sensor from the cylinder block. To install, simply follow the removal procedure in reverse.

For 1993 and 1994 models, you should wait for the engine to cool completely before performing the procedure. Drain the cooling system, raise the vehicle, and support it securely on jackstands. Disconnect the knock sensor harness connector, detach any retaining clips, remove the knock sensor from the engine block, and then follow the reverse process for installation, including refilling the cooling system.