Nissan 11350-21P00 Engine Mount Member Assembly, Rear

You can Select Your Vehicle to check if 11350-21P00 fits your vehicle.

Lift the car and place it on jack-stands properly as the car is going to be shaken slightly during the checking and replacement of the mounts. Press on the extension housing of the transmission and check the range of motion to this action, then, pulling down on the extension housing and figuring out the motion range to this type of action. If the extension housing can be pushed up a farther distance than it can be pulled down, it means that the rubber is long molded and the mount sunk to the lowest point. Furthermore, if the rubber part of the mount is disconnected from the metal plate when one shakes it upwards, the mount must be replaced. The front exhaust tube needs to be disconnected, but before that, it has to be ensured that the connector of the catalytic converter to the body is properly made. One has to place a jack and put a block of wood between this jack and the transmission to prevent the marks left by the jack. Subsequently, the two through bolts and washers that attach the mount to the crossmember have to be loosened and disconnected, then the four bolts and washers for the crossmember-BODY connection should be undone, and finally the crossmember can be taken off. Lastly, two bolts that hold the mount on the transmission must be undone, and the mount has to be removed, though the instructions would be based on the removal process.