Nissan 24820-4Y921 Speedometer Assembly

You can Select Your Vehicle to check if 24820-4Y921 fits your vehicle.

Unplug the electrical connectors and remove the cluster from the vehicle.

1. Disconnect the wiring harnesses (behind the upper and lower center trim panels). 2. Remove two screws from the front of the navigation control unit, pull aside the carpet on the left of the unit, and remove three more screws. Unplug the electrical connectors and take the unit out. 3. Remove four screws that secure the center stack. Disconnect the wiring harnesses and GPS antenna and remove the center stack from the vehicle. 4. Remove the instrument cluster (see Chapter 12). 5. Remove the passenger airbag (see Chapter 12). 6. Remove the ignition switch trim cover. 7. Remove the driver's side knee bolster. 8. Pull the tilt switch out from under the steering column and unplug its wiring connector. 9. Remove the front door trim welting far enough to get it out of the way for instrument panel removal. Remove the door scuff plates. 10. Remove the trim from both front door pillars. 11. Remove the lower dash trim panels and steering column covers. 12. Disconnect the steering column electrical connector and move the harness out of the way. 13. Remove the pinch bolt that secures the steering column to the lower joint. Detach and lower the steering column. 14. Remove the instrument panel mounting screws. Disconnect the remaining electrical connectors and remove the instrument panel from the vehicle. 15. Installation is the reverse of the removal steps.