Nissan D1060-1HL0B Front Brake Pads Kit

You can Select Your Vehicle to check if D1060-1HL0B fits your vehicle.

Remove the cap from the brake fluid reservoir, then loosen the front or rear wheel lug nuts and raise the vehicle, supporting it securely on jackstands while blocking the wheels at the opposite end. Remove the wheels and work on one brake assembly at a time, using the assembled brake for reference if needed. Inspect the brake disc carefully, and if machining is necessary, follow the appropriate steps to remove the disc. Push the piston back into its bore to create space for the new brake pads, using a C-clamp for this task, except for rear calipers with an Electric Parking Brake. As the piston is depressed, ensure that the fluid in the master cylinder does not overflow, siphoning off some if necessary. Wash the brake thoroughly with brake system cleaner and allow it to dry, positioning a drain pan underneath to catch any residue. Remove the caliper lower mounting bolt without detaching the brake hose banjo bolt unless servicing is required. Pivot the caliper up and secure it with a piece of wire. For 2009 and later models, remove the pad retraction spring(s) as applicable. Remove the inner and outer brake pads, along with the lower and upper pad retainers. Clean and lubricate the caliper slide pins with high-temperature brake grease before reinstalling them. Install the pad retainers and shim, applying anti-squeal compound to the back of both pads and allowing it to set before installation. Install the inner brake pad and shim, ensuring the wear indicator is correctly positioned, followed by the outer brake pad, noting the orientation of the wear indicator and spring. For 2009 and later models, install the pad retraction spring(s) and then swing the caliper down, tightening the caliper mounting bolt to the specified torque. When reinstalling the caliper, ensure the mounting bolts and wheel lug nuts are tightened to the correct torque. After completing the job, firmly depress the brake pedal several times to bring the pads into contact with the disc, check the brake fluid level and add if necessary, and carefully check the operation of the brakes before returning the vehicle to normal service.

According to the supplied VIN, PN: D1060-1HL0B is the correct part number for the front brake pads. This does come as a set to service both front wheels. Thanks

THAT IS THE CORRECT PART NUMBER