Nissan 54303-0B087 STRUT Kit Front LH

You can Select Your Vehicle to check if 54303-0B087 fits your vehicle.

To check for play, move the wheel in and out while looking for movement at the steering knuckle-to-control arm balljoint. Additionally, grasp the tires and feel for any freeplay in the steering system components. If any play is detected, it may indicate worn or damaged parts that need replacement.

If replacing the lower insulator, set it into position with the dropped portion seated in the lowest part of the seat, extend the damper rod fully, and install the dust boot. Place the compressed coil spring onto the lower insulator, ensuring the end rests in the lowest part of the insulator. Install the upper insulator and spring seat, ensuring the cutout on the spring seat faces out, in line with the strut-to-knuckle flange opening. Install the bearing onto the spring seat, followed by the dust seal and suspension support to the damper shaft. Finally, install and tighten the nut to the specified torque, carefully release the tension on the spring, and remove the spring compressor before installing the strut coil spring assembly.

Check the strut body for leaking fluid, dents, cracks, and other obvious damage that would warrant repair or replacement, and inspect the coil spring for chips or cracks in the coating, as well as the spring seat for cuts, hardness, and general deterioration.

The first step in the installation process is to position the shock absorber onto its mounts.