Nissan 25540-2Y901 Switch Assy-Turn Signal

You can Select Your Vehicle to check if 25540-2Y901 fits your vehicle.

1. Disconnect the cable from the negative terminal of the battery. 2. Remove the steering wheel (see Chapter 10). 3. Remove the driver's knee bolster and steering column covers (see Chapter 11). 4. Remove the four screws retaining the airbag clockspring and remove the clockspring from the combination switch (see Chapter 10). Remove the combination switch retaining screws (the combination switch is held in place by three screws). 5. Remove the combination switch. Slide the switch up off the column and unplug the connectors (unplug the electrical connectors from the combination switch). 6. Remove the retaining screws from the switch being replaced and remove the defective switch from the switch body (remove individual switches by removing the mounting screws). Insert the terminals from the new switch into the connector, pushing in until they are securely locked in place. 7. The remainder of the installation is the reverse of removal. Refer to Chapter 10 and center the clockspring before installing the steering wheel.