Nissan 21200-40F00 Thermostat Assembly

You can Select Your Vehicle to check if 21200-40F00 fits your vehicle.

On 200SX V6 engine, it may be necessary to remove the radiator shroud, coolant fan assembly, and water suction pipe retaining bolts to gain access to the thermostat housing. First, drain the engine coolant into a clean container so that the level is below the thermostat housing. Then, disconnect the upper radiator hose at the water outlet. Loosen the two securing nuts and remove the water outlet, gasket, and the thermostat from the thermostat housing. To install, place the thermostat to the engine, using a new gasket with sealer and with the thermostat spring toward the inside of the engine. Reconnect the upper radiator hose. Refill and bleed the cooling system. Make sure to let the engine reach normal operating temperature then check coolant for the correct level. For cooling system bleeding, remove the radiator cap. Fill the radiator and reservoir tank with the proper type of coolant. If equipped with an air relief plug, remove the plug and add coolant until it spills out the air relief opening. Install the plug. Install and tighten the radiator cap. Start the engine and allow the coolant to come up to operating temperature. If equipped, allow the electric cooling fan to come on at least once. Run the heater at full force and with the temperature lever in the HOT position. Be sure the heater control valve is functioning. Shut the engine off and recheck the coolant level, refill as necessary.

PN: 21200-40F00 does not come with a gasket. I do not see one offered by Nissan. It does state that you would need to use PN: 999MP for the inlet. For PN: 11057-H5000, you would need to order PN: 11058-H1001 for the washers. As far as the Hex nuts for PN: 14064-58Y00, I do not see any.