Genuine Nissan Titan Intake Valve

Nissan Titan Intake Valve Parts Questions & Answers

• Valve Intake
  13201-9FP0A
  Q: How to check and adjust valve clearance after replace camshaft(s) or valve-related parts on Nissan Titan?

  A: The manufacturer recommends checking and, if necessary, adjusting the valve clearance after replacing the camshaft(s) or other valve-related parts, or if the valve train is making excessive noise. Begin by disconnecting the cable from the negative terminal of the battery, then remove the spark plugs. Position the number 1 piston at TDC on the compression stroke and align the timing marks before removing the valve covers. Check that the intake and exhaust camshaft lobes for cylinder number 1 are pointed outward. Measure the clearance of the indicated valves with a feeler gauge; at TDC for number one cylinder, the intake valve clearance for cylinders no. 1, no. 2, no. 4, and no. 5 can be measured, along with the exhaust clearance for cylinders no. 1, no. 7, and no. 8. Record each measurement and compare with the desired valve clearance specifications, noting any that are out of specification for later determination of required replacement lifters. Turn the crankshaft 270 degrees clockwise to place cylinder number 3 at TDC and measure the clearances of the indicated valves, then turn the crankshaft 90 degrees clockwise to TDC for cylinder number 6 and measure the clearances for the indicated valves. If a lifter is out of specification for clearance, it must be replaced with a new lifter of a different thickness to correct the clearance. Mark the lifters to be replaced and record their origin, using a micrometer to measure the thickness of the lifter head precisely. To calculate the correct thickness for a replacement lifter that will achieve the specified valve clearance, use the formula: N = R + (M1 - M2), where N is the thickness of the new lifter, R is the thickness of the old lifter, M1 is the measured valve clearance, and M2 is the standard valve clearance. New lifters are available in 25 standard thicknesses, ranging from 0.3102 inch to 0.3291 inch, marked on the underside to indicate their size. Mark the new lifters for their destination, lubricate them with engine assembly lube, and install them. After replacing the lifters, reinstall the camshafts and timing chains, then re-check the valve clearances.