Nissan 26261-C9903 Bulb

You can Select Your Vehicle to check if 26261-C9903 fits your vehicle.

Remove the front corner inner fender well mounting screws and pull the liner back. Reach up behind the headlight housing and disconnect the electrical connector for the bulb to be replaced, then rotate the bulb counterclockwise and remove it from the housing. Insert the new bulb assembly into the headlight housing without touching the glass with bare fingers, and rotate the bulb clockwise to lock it into place. Finally, plug in the electrical connector and test headlight operation before reinstalling the inner fender liner mounting fasteners.

For all other models, detach the clips from the sides of the fog light lens, pull out the lens, disconnect the electrical connector, disengage the retaining spring, and detach the bulb from the lens. If necessary, remove the nut securing the fog light to its retaining bracket.

Without touching the glass with your bare fingers, insert the new bulb assembly into the headlight housing and secure it with the retaining ring or clip.

Models equipped with halogen bulbs have separate headlight bulbs for the high and low beams.

Insert the new bulb assembly into the headlight housing without touching the glass with bare fingers.

Disconnect the electrical connector from the headlight bulb holder, then twist the bulb counterclockwise to remove it from the housing.

The first step is to ensure the headlight switch is off and disconnect the cable from the negative terminal of the battery.

Twist the bulb holder counterclockwise and pull it out; the headlight bulbs can be reached once the inner fender liner is detached and pulled back.

To replace the license plate light, you should remove the screws and pull the housing from the bumper on Frontier models, unsnap the housing from the bumper on Xterra models, or remove the screws and pull the housing from the liftgate on Pathfinder models. Pull the bulb straight out to replace it.

Other 2003 models and all 2004 through 2006 Sedans utilize Xenon low-beam bulbs and halogen high-beam/fog bulbs.

Unplug the electrical connector and remove the rubber boot if equipped.

Without touching the glass with your bare fingers, insert the new bulb assembly into the headlight housing and secure it with the retaining ring.