Nissan 43206-JA00B Rotor Brake

You can Select Your Vehicle to check if 43206-JA00B fits your vehicle.

Loosen the wheel lug nuts, raise the vehicle, and support it securely on jackstands. Remove the wheel and install the lug nuts to hold the disc in place; if the lug nuts don't contact the disc when screwed on all the way, install washers under them. Remove the brake caliper without disconnecting the brake hose, and suspend the caliper out of the way with a piece of wire after removing the caliper bolts. Visually inspect the disc surface for score marks and other damage; light scratches and shallow grooves are normal, but deep scoring over 0.039-inch (1.0 mm) requires disc removal and refinishing. Check both sides of the disc, as severe wear may necessitate replacement. If pulsating occurs during brake application, suspect disc runout. To check runout, place a dial indicator about 112-inch from the outer edge of the disc, set it to zero, and turn the disc; the reading should not exceed the allowable runout limit. Resurfacing the discs when replacing brake pads is advisable to ensure a smooth finish and eliminate brake pedal pulsation. If not resurfacing, remove the glaze from the surface with emery cloth using a swirling motion. Ensure the disc is not machined to a thickness under the specified minimum allowable refinish thickness, which can be checked with a micrometer. Remove the two caliper mounting bracket bolts and detach the caliper mounting bracket, fully releasing the parking brake on rear discs. Remove the lug nuts holding the disc in place and take the disc off the hub; if a rear disc is stuck, remove the rubber plug from the parking brake adjuster hole and use a small screwdriver to turn the star wheel and retract the parking brake shoes. Place the disc in position over the threaded studs, install the caliper mounting bracket over the disc, and tighten the bolts to the specified torque. Install the caliper and tighten the bolts to the specified torque, then install the wheel, lower the vehicle to the ground, and tighten the lug nuts to the specified torque. Depress the brake pedal a few times to bring the brake pads into contact with the disc, and check the operation of the brakes carefully before driving the vehicle.