Nissan 25320-AX00C Stop Lamp Switch Assembly

You can Select Your Vehicle to check if 25320-AX00C fits your vehicle.

On 2013 and earlier models and 2014 and later Rogue Select models, the Cruise Control Switch is known as the ASCD (Automatic Speed Control Device) switch, while on 2014 and later models (excluding Rogue Select models), it has been replaced by the brake pedal position sensor. The brake light switch and Cruise Control Switch or brake pedal position sensor are located on a bracket near the top of the brake pedal, activating the brake lights when the pedal is depressed and canceling cruise control operation. To check the brake light switch, observe whether the brake lights illuminate when the pedal is pressed and turn off when released. If the brake lights do not activate or the cruise control does not cancel, ensure the brake pedal is correctly adjusted, then adjust the switch by turning it counterclockwise 45 degrees, pulling the brake pedal back while pushing the switch into its bracket until the threaded portion touches its stop, and finally turning the switch 45 degrees clockwise to secure it. For replacement, unplug the electrical connector from the switch, turn the switch 45 degrees counterclockwise, pull it to the rear to remove it, and then install the new switch in reverse order. After installation, adjust the brake pedal height and then adjust the switch accordingly.

If equipped, the lower instrument panel insulator below the driver's side knee bolster should be removed to access the brake light switch.

The brake light and cruise control cancel switches are located on a bracket near the top of the brake pedal.

The cruise control cancel switch is located on a bracket near the top of the brake pedal.

To start, depress and hold the brake pedal. Then, rotate the brake light switch about 45 degrees counter clockwise to detach it from its bracket.

Next, remove the facia lower trim panel on the driver's side and disconnect the switch wiring connector from the switch.

To replace the switch, unplug the electrical connector from the switch, turn it 45 degrees counter-clockwise, pull it to the rear, and remove it. Installation follows the reverse order of removal, followed by adjusting the brake pedal height and the switch.